3/28/2023 0 Comments Rocrail xpressnet settings![]() But instructions for loco's and accessories, is that done via the canbus? or is this also done via the router (<- this is my guess).ġ). ![]() I am also guessing that things like the loco list and control panel layouts are synchronized via ethernet instead of their can bus. What I absolutely do not know is where the can bus between master-slave is used for besides the described booster part. I believe (still guessing here) that the canbus is primarily used to relay information between trackpower and shortcircuit and such. I am guessing that the can bus cable in this case is used in a similar fashion as the boosters. I am aware that the rail signals are also present in this cable, so that the slave central station's power unit will act as a booster device. The manual does not give a clear explanation (or I looked at the wrong manual). What I would like to know is if I need a the can bus connection. The slave unit also has an S88 bus which also has to makes it's way to iTrain. The goal is to synchronize the locolists and to have a better operation in iTrain. Both are still connected to the same router. Right now I want to configure one of the central stations as a slave and the other as a master. I don't want to discuss this here and now. Or I can synchronize both railsignals by feeding both layouts by the same booster circuit. Electrically this can be done galvanically isolated by making a transition part where I use a relay to switch from one Cs3 to the other. However if both central stations have the same addresses, which train I am going to control? Address 24 on interface 1 or Address 24 on interface 2?īoth separate circruits, will eventually be connected. I have also added a roco Z21 WLAN maus to iTrain with which I can control trains by entering an address. So in iTrain I have 2 merged loco lists, half of the locos belong to interface 1 and the other half to interface 2. Both central stations are added in iTrain being separate interfaces. I have connected both CS3 devices to an iTrain computer using ethernet cables and a WLAN router. At our model railway club we have 2 central station 3+, which are at least 15 meters apart. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |